MOOSE ZXSSD Guide de l'utilisateur télécharger pdf (Page 16)

Enter For: 0123456789ABCDEF

First Digit

All Features Below Disabled *

Two Button Arm ********

Double Button Press Arm * * * * * * * *

Open After Alarm **** ****

Display Bypassed Armed ********

Second Digit

Double Press Panic Keys ********

Bypass ********

Force-Arm * * * * * * * *

Exit Arm **** ****

3 Second Panic Keys ********

NOTE: If the First Digit entered is ‘1’, it must be entered as ‘01’. A = 10; B = 11; C = 12; D = 13; E = 14; F = 15

Area Attribute Table

Bypassing - enables selective bypassing of any zone that is defined

as bypassable in this area.

Force-Arming - permits arming of the area with zones faulted.

Faulted zones are temporarily bypassed and return to operation if the

fault is corrected. Only zones that are defined as bypassable may be

force-armed. See Section 3.3, Programming Note 4.

Exit Arm - see Section 3.3, Programming Note 3.

3 Second Panic Keys - requires all panic keys to be pressed and held

for approximately 3 seconds in order to activate alarm condition.

Only pertains to Control Stations that are Primary to this area.

Double Press Panic Keys - requires all panic keys to be pressed

twice within one second to activate. Only pertains to control stations

that are Primary to this area.

Two Button Arm - enables quick arming by pressing AWAY, STAY,

or NIGHT followed by the ENTER key. Cannot be used with force-

arming

Double Press Arm - enables quick arming by pressing AWAY, STAY,

or NIGHT twice. Cannot be used with force-arming.

Open After Alarm - enables opening reports to be reported only if

they occur after an alarm. All “opening” events will be logged in the

Event Log regardless of setting.

Display Bypass Armed - when armed in STAY or NIGHT mode with

bypassed or force-armed zones, Control Stations with the area as the

Primary area will indicate that there are zones that are bypassed.

Area Attributes 00 to FF

(see the Area Attribute Table)

WWW.DIYALARMFORUM.COM

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 51 52

Pas de commentaire

MOOSE ZXSSD Guide de l'utilisateur Page 16